Holley EFI HolleySport EV1 Milspec Injector Harness

The HolleySport EV1 Milspec injector harness utilizes Raychem DR-25 heatshrink tubing and transitions, providing protection from extreme temperatures and external contaminations that frequently cause reliability issues. The injector connectors and pins are Bosch Motorsports pieces featuring double spring contacts and sealed boots. The injector harness is designed and labeled for conventional 1-3-5-7 and 2-4-6-8 cylinder layouts (Small, Big Block, LS Chevrolet and many others). Additionally, this injector harnesses includes a mating 12-Pin Deutsch connector and pins, allowing you to easily upgrade any wiring harness that utilizes EV1 injectors.FeaturesBolt on 4150 Flange Carburetor ReplacementSupports up to 650HP with Four 100lb/hr InjectorsTerminator X Max Stealth 4150 kits provide transmission control for Pre-2009 GM 4L60E/4L80E Transmissions (Part numbers 550-1011, 550-1012,550-1013)Internal 1bar MAP sensor, built into the Terminator X ECU.All of the wiring exits below the rear fuel injector cover, for a completely stealth installationTimed spark part for vacuum advanced distributors located under the front fuel bowl, for easy access to the distributorAir entry is machined to fit most stock style air cleaners with air cleaner locator provisionsExternal fuel pressure regulator required, set to a base pressure of 58.5 PSI, such as Holley part # 12-886Integrated ignition timing control improves idle stability, fuel economy, and wide open throttle performanceHigh Resolution Full Color Touchscreen for Initial Setup, Tuning, and Gauge DisplaysSimple Calibration Wizard (answer a few questions about your engine and it creates the base map, then starts tuning on its own!) - NO laptop requiredThe included Genuine Bosch LSU 4.9 Wideband Oxygen Sensor provides real-time Fuel Map LearnOEM Style TPS/IAC for years of dependable serviceAvailable in 3 finishes: Shiny, Black, and Gold