Front-feed Dual Injector manifold and fuel rails-Black finish
The Holley LS1/2/6 Ultra Lo-Ram intake manifold kits are designed for GM LS Gen III and IV engines equipped with GM LS1/2/6 (cathedral port) cylinder heads. These intake manifold and rail kits will work with OE (Original Equipment) or aftermarket cylinder heads.
The 300-603(satin) & 300-603BK(black) front-feed, base-lower intake manifold provides two injectors per cylinder for hi-volume fuel demands, flexible fuel supply strategies, and dual-fuel capability. Offering this base intake manifold with fuels rails separately allows you to select your components individually as you build your induction system. Complete front-feed manifold kits are also available with dual fuel injectors, see P/N's 300-625 & 300-625BK. The front-feed, short runner, low-profile base intake manifold was conceived to package with high-boost turbocharged or supercharged induction systems with a short overall height not possible with other existing intake manifolds. The Holley Lo-Ram complete intake manifold kits and throttle body adapters available as a machined casting 300-606 & 300-606BK are configured for a 105mm throttle body, see Holley P/N 112-581 or similar models. The fuel rail kits come with two sets of brackets. A set for long (usually standard length) fuel injectors and a set for short (such as Pico, or LS7) fuel injectors.
Holley Lo-Ram intake manifold kits include all the sealing o-rings, plugs, and fasteners required for the installation of the kit.FeaturesPlug and play GM Gen V LT engine control including GDI and VVT supportIdeal for swapping late model GM Gen V LT engines into vintage vehicles3.5” handheld gets your engine running in no time with a step-by-step calibration wizardGM LS and LT Drive-by Wire Throttle Body Control (Terminator X Max Only)GM 4L60 and 4L80 Transmission Control (Terminator X Max Only)Included engine harness plugs directly into the factory LT DI injector sub harnessOEM Injectors supported, with part numbers provided in the handheld wizard, or softwareGenuine Bosch LSU 4.9 Wideband Control (Will not work with LSU 4.2 Oxygen Sensors)• Genuine Bosch LSU 4.9 Wideband Control (Will not work with LSU 4.2 Oxygen Sensors)On-Board Diagnostic LEDS for: ECU Power – Engine Run – Wideband Status – TPS Calibration – Crank Signal – Cam Signal – VVT Status – Pump Control – and DI Injectors. Allowing you to identify any Critical engine issues at a glanceBuilt in 1bar MAP Sensor, vacuum hose adapters included (1/8th – ¼ and 3/16ths) - or for Boosted applications, you can disable the internal MAP sensor, and utilize an external LT MAP Sensor, the harness comes with the connector terminated, making the inst4 Inputs – 12v, Ground, 5v, and Frequency, for things such as additional pressure sensors, or activation triggers for nitrous activation, or a trans brake (Fuel and Oil Pressure Inputs are pre-terminated)4 Outputs – Ground, PWM - , for accessories such as; fans, boost control, nitrous control, IAC Kit, and moreBoost Control – Boost vs Time, Boost vs Gear, Boost vs RPM, Boost vs Speed, Boost SafetiesNitrous Control – Single Channel of Wet or Dry, Progressive or Non-Progressive, Rich/Lean Safeties, and target Closed Loop AFRAdvanced Tables – 4x 1D Tables, 1x 1D per Gear Table, 4x 2D Tables, 1x 2D per Gear TableIntegrated data logging to the 3.5” Handheld SD CardFree EFI Tuning Software for complete control of your Terminator X power plant
