Billet Burst Panel Duct Clear Anodized Finish
The P/N 300-608 & 300-608BK Lo-Ram billet burst panel ducts are designed to complement the Holley LS Ultra Lo-Ram EFI intake manifold kits. The Ultra Lo-Ram kits are intended for boosted engine applications where the requirement of an intake manifold plenum burst panel may be recommended to protect the engine from an intake plenum backfire. The 300-608 & 300-608BK Ultra Lo-Ram billet burst panel ducts are made for a standard "large" 6-1/8" x 3-1/8" burst panel. SFI Approved Burst panels, burst panel frame sets, and gaskets may be purchased from various manufacturers such as Allstar Performance or Specialty Fasteners.
P/N 300-608 has a clear anodized finish and P/N 300-608BK has a black anodized finish. Mounting fasteners are included in the kit.FeaturesPlug and play GM Gen V LT engine control including GDI and VVT supportIdeal for swapping late model GM Gen V LT engines into vintage vehicles3.5” handheld gets your engine running in no time with a step-by-step calibration wizardGM LS and LT Drive-by Wire Throttle Body Control (Terminator X Max Only)GM 4L60 and 4L80 Transmission Control (Terminator X Max Only)Included engine harness plugs directly into the factory LT DI injector sub harnessOEM Injectors supported, with part numbers provided in the handheld wizard, or softwareGenuine Bosch LSU 4.9 Wideband Control (Will not work with LSU 4.2 Oxygen Sensors)• Genuine Bosch LSU 4.9 Wideband Control (Will not work with LSU 4.2 Oxygen Sensors)On-Board Diagnostic LEDS for: ECU Power – Engine Run – Wideband Status – TPS Calibration – Crank Signal – Cam Signal – VVT Status – Pump Control – and DI Injectors. Allowing you to identify any Critical engine issues at a glanceBuilt in 1bar MAP Sensor, vacuum hose adapters included (1/8th – ¼ and 3/16ths) - or for Boosted applications, you can disable the internal MAP sensor, and utilize an external LT MAP Sensor, the harness comes with the connector terminated, making the inst4 Inputs – 12v, Ground, 5v, and Frequency, for things such as additional pressure sensors, or activation triggers for nitrous activation, or a trans brake (Fuel and Oil Pressure Inputs are pre-terminated)4 Outputs – Ground, PWM - , for accessories such as; fans, boost control, nitrous control, IAC Kit, and moreBoost Control – Boost vs Time, Boost vs Gear, Boost vs RPM, Boost vs Speed, Boost SafetiesNitrous Control – Single Channel of Wet or Dry, Progressive or Non-Progressive, Rich/Lean Safeties, and target Closed Loop AFRAdvanced Tables – 4x 1D Tables, 1x 1D per Gear Table, 4x 2D Tables, 1x 2D per Gear TableIntegrated data logging to the 3.5” Handheld SD CardFree EFI Tuning Software for complete control of your Terminator X power plant
